Slot Car Racing

Two pairs of 2.38mm (3/32nd) I.D. brass axle bushes for retro-fitting to other brand cars for upgrading mechanical drive trainSuit Slot.it, Policar...

17.3mm x 9.75mm wheels with short 1.5mm inner boss. Previously known as PA62-als Suits GT and LMP cars. This is the wider hub, generally called a "...

17.3mm x 8.2mm wheels with short 1.5mm inner hub for GT and LMP cars- Wheel with 17.3 x 8.2 mm rim width and short hub (1.5 mm). - The short hub is...

Standard wheel for Group C cars at rear. Also standard on Sideways Group 5 cars.Previously known as PA43als. Has the short 1.5mm inner bossA slight...

Replaces: PA24-Als (2 'OZ Type' inserts removed)Same as original small wheel PA24-als,  has narrower 1.5mm inner hub than the w15808225 version for...

High flexibility replacement silicon cable in 1 metre lengthsRed copper cable with thermal resisting silicone sleeve, 23 AWG (0.25mm2)With reduced ...

Slot.it SP18 Copper Braid (Tinned) - 1 metre lengthSuper soft tinned copper braid for non-magnet racing. Enable the guide to sit deep in the slot w...

 Brass Eyelets (10 pack) for front wheel axles

One Metre of extra soft copper braid.  Allows the guide to sit deep in the slot without "bounce"

SIPS11 Slot.it brass pinion gears are designed for use with Slot.it crown (inline), sidewinder and anglewinder driven gears.  This pinion gear has ...

Pinions 10 teeth Ø6 mm (2x) – internal Ø: 1,5 mmNew product / replacement: New 5/15/13 This pinion can be used on models from all brands using a mo...

Brass PinionScalextric F1 Type MotorsOD: 5.5mmID (Motor Shaft): 1.5mmPack of 2This kind of pinion was conceived to be used as spare part for models...

2x tempered axles Length 51mm D. 2.38mm (3/32nd") axles 

36 teeth, lightened, hex screw M2, ergal, Ø19mm

28 teeth Step2 crown, Bz insert

24 teeth, Step2 crown, Bz insert

F22 compound soft rubber Suits Slot.it F1 wheels   20.4mm x 12.4 mm wideDWG 1068Approximate diameter on hubs prior to truing14.4mm F1 hubs  20.8mmP...

Z0 compound (x4) "Zero Grip" - fronts onlyDWG 1067 Ultra low profile Approximate diameter on hubs prior to truing15.8mm hubs  17.0mm16.5mm hubs  17...

6mm 11 tooth pinion for use with flat 6 motor in anglewinder configuration

Light aluminium stopper for anglewinder setup (2x)- Anozided and teflon plated. - Weight: 0.1 g.

2x 54mm 2.38mm diameter (3/32nd") axles

S-Can dual end shaft for can or endbell drive.Standard Motor for Slot.it Group C and as sidewinder mount in 65 - 80 Sports classics models.This is ...

Replacement: KK15 (2 'BBS' GT inserts removed)This kit is similar to the KK02, but includes wheels 17.3*8 instead of 15*8.This kit was developed to...

Replaces: KK07b (2 'BBS' GT inserts removed)The pack includes:- 3 grub screws L3 (PA40)- 1 inline bronze Z28 crown (GI28-bz yellow)- 1 axle 54 mm (...